Anyone know why my pond wouldn’t be considered an infinite water source? Whenever I take water from it, the water level at that spot is lower and I have to temporarily place dirt blocks underneath to even it out again.
Is your tps lagging? If you have atleast two water source blocks with a 1 block gap between their path of flow it will cause a infinite water source
MicrowavedTheBaby on
do you have the immersive fluids mod or something?
girlkid68421 on
If you’re taking it from the middle thats why
YourLeftNutsicle on
Is every block a water source block? Idk, I’m trying my best sorry if that’s not the issue
EveDaSavage on
Did you fill the pond by putting water on flat dirt, then breaking the dirt so the water falls?
AurorasDemise on
if the layer(s) underneath the top arent source blocks, then the top layer wont properly replenish itself
adderthesnakegal on
put kelp on each block, bonemeal until it reaches the top, then break the kelp. should convert them all to source blocks and fix the issue
Baldersmashed on
Use kelp on every block on the bottom and build it up to the water’s surface in every space. Boom. Watwr source blocks.
DedCheeseCake on
The water seems to be dry. Go get some from the ocean
PcPotato7 on
If the water at the bottom is not water sources, but instead flowing water, then the top layer will not replenish.
To fix this, you could either add kelp to each block, converting the flowing water to a source, or drain and refill the pond one layer at a time by placing water along the perimeter of each layer
Feather_Bloom on
Fill it all out with kelp and remove, they’ll turn it all into source
11 Comments
Is your tps lagging? If you have atleast two water source blocks with a 1 block gap between their path of flow it will cause a infinite water source
do you have the immersive fluids mod or something?
If you’re taking it from the middle thats why
Is every block a water source block? Idk, I’m trying my best sorry if that’s not the issue
Did you fill the pond by putting water on flat dirt, then breaking the dirt so the water falls?
if the layer(s) underneath the top arent source blocks, then the top layer wont properly replenish itself
put kelp on each block, bonemeal until it reaches the top, then break the kelp. should convert them all to source blocks and fix the issue
Use kelp on every block on the bottom and build it up to the water’s surface in every space. Boom. Watwr source blocks.
The water seems to be dry. Go get some from the ocean
If the water at the bottom is not water sources, but instead flowing water, then the top layer will not replenish.
To fix this, you could either add kelp to each block, converting the flowing water to a source, or drain and refill the pond one layer at a time by placing water along the perimeter of each layer
Fill it all out with kelp and remove, they’ll turn it all into source